Disconnect minus cable from battery.
Remove rear seat.
Remove rear seat backrest. To do this, unscrew bolt (1) at left and right-hand side.

Place mounting plate for rear loudspeaker upside down
on the middle of the parcel shelf and mark holes to be
drilled.
Holes 1 ÷ 4 have dia. of 5 mm (0.19685").
Hole 5 has dia. of 8 mm (0.31496").
Note when fitting: A = 142 mm (5.5905").

Fasten base plate with nuts 1 ÷ 4 and press rear loudspeaker cable through hole (5).

Connect rear loudspeaker and fasten to base plate.

Lead cable from rear loudspeaker along loom to the
front.

Load cable from rear loudspeaker to the middle of the
steering column.

Unscrew bolts 1 ÷ 3 and remove sleeve covering steering
column.

Unscrew bolts 1 ÷ 4 and remove instrument panel cover
(middle section) at bottom.

Remove central plug (1) from hazard warning flasher
switch and central plug (2) from rear fog warning light
switch. Pull cable off switch for heated rear window (3).
Note when fitting:
brown cable plug 31
black/red cable plug S
green/blue cable plug +

Remove loudspeaker grille.

Unscrew bolts 1 ÷ 4 and take out loudspeaker. Pull off
loudspeaker cables and lay towards balance knob.Connnect
cable provided in assembly kit to loudspeaker.
Connect plugs with colours to match and also to lay towards
balance knob.

Connect cables to balance knob.
Connect brown cable from car radio, brown cable from
loudspeaker and brown cable from rear loudspeaker to
the three combined sockets (1).

Connect brown/red cable from the car radio to central
contact "X" (2).
Connect the brown/red cables from the loudspeaker and
rear loudspeaker to the terminals still left free.

Drill a hole with 10 mm (0.3937") dia. in the lower central
section of the instrument panel cover and fit on balance
knob.
A = 190 mm (7.4803").