Disconnect minus cable from battery.
Remove left-hand rear seat.
Unscrew bolts (1) and (2) and remove armrest.

Press rocker switch out of armrest and pull off cables.
Note when fitting:
green/blue cable terminal 30
black/red cable terminal 32
green/yellow cable terminal 33
Position of rocker switch when assembling:
Push button upwards to close window
Push button downwards to open window

Unscrew the two rear bolts on the bottom strip (at bottom
of door).

Remove side lining from clamps and take off.

Unscrew bolts 1 ÷ 4 from upper strip on door.

Turn side window downwards and unscrew bolt (5).
Pull out upper door strip to the top.
Note when fitting: Attach rubber piece (6) to upper door
strip.

Unscrew bolts (1) and (2).
Carefully remove Acella foil and insulating paper.

Disconnect cables from cable connector terminal.
Note when fitting: Connect cables with colours to match.

Unscrew bolts 1 ÷ 6 and take out electric window lift together
with side window.
Note when fitting: Bolts 1, 2 and 4 are shorter than the
others.
Stop A.
Move window upwards. Screw out stop by one turn and
lock, so that engine switches off shortly before upper point
is reached.
Stop B.
Move window downwards and adjust stop in such a way
that the upper edge of the window stops about 30 mm
(1.1811") above the window recess opening.
Carry out this procedure in the same way for the left-hand
and right-hand side windows.
For adjustment of side windows cf. note when fitting 51 37 171.


51 37 171