Pull off the hub cap.
Loosen the wheel nuts.
Note: The wheel has been electronically balanced. Before
removing, mark wheel position in relating to wheel hub.

Do not lift the car under the end plate of the front axle
beam.
Use a lifting rail.
Warning: Cars with a corrugated front axle beam end
plate may be lifted without a lifting rail.

Support the body on a stand with a wooden packing piece
interposed. This can be made up in your own workshop.
Place the wide cutout under the side of the vehicle on
which the fuel line is located. The narrow edge should face
inwards.

Sketch for making up lifting rail.
C to suit vehicle hoist pick up point.