Press track rod off track rod arm - use tool No. 6056.

Remove safety wire.
Take track rod arm off spring strut.
Screw off castellated nut.
Press track rod arm off cross member - use Kukko press tool.

Note when assembling: Check track rod arm.
A = 53.5 mm (2.1063") from steering drop arm (US: pitman arm) to bearing surface
of spring strut measured in longitudinal direction as from the middle of the bore.

Important: Use track rod arm with a boss only if the cross member
also has a boss.
Never use track rod arm with a boss together with a cross member without a boss.
On the other hand, however, a track rod arm without a boss may be used in the
cross member has a boss.