Detach wheels 36 10 340.
Remove securing wire.
Disconnect track rod arm from spring/shock absorber strut.

Press guide joint out of track rod arm - Kukko extractor.

Detach wishbone from front axle carrier.
Fitting instruction: Tighten stop nut in normal position¹).
Spacher ring (1) positioned at the front axle carrier.


¹) See technical data.

Detach trailing link from wishbone.
Fitting instruction: Convex outer radius of washers (1)
facing the rubber bush.
Guide joint or wishbone must be replaced if the axial play
(S) exceeds 2.4 mm (0.0945").
Warning: Wishbone with stop (A) may be installed in con-
junction with track rod arms without stop.
However, never install a wishbone without stop (A) in con-
junction with a track rod arm with stop.
See also 32 21 101.