Remove entire exhaust system - see 18 00 020.
Detach the propeller shaft at the driven flange and center
holder. Bend down the propeller shaft and pull it off of
the centering pin.
Note when fitting: Pre-load the center holder in driving
direction by 2 mm (0.079").

12011001 - click to zoom
 
Pull off stop pad (1).
Lift out lockplate.
Note when fitting: Punch the lockplate in the driven
flange groove.

12011002 - click to zoom
 
Counterhold the driven flange with holder 604.
Place centering bush 607 on the centering pin.
Loosen the collared nut.
Pull off the driven flange.

12011003 - click to zoom
 
Remove the radial oil seal with extractor 7051.

12011004 - click to zoom
 
Note when fitting: Drive in new radial oil seal with
mandrel 7053.

12011005 - click to zoom
 
Fill the cavity between the sealing lips with a branded
all-purpose grease.
Caution! Do not drive in the radial oil seal to the stop.
Distance A of 3 mm (0.118") must be kept.

12011006 - click to zoom