Drain oil.
Caution! Never reuse drained oil.
Note when fitting: If the oil has a burnt odor and black
discolouration, the transmission must be disassembled. If
the oil has a silver-grey glow, this concerns aluminium or
iron dust. In contradiction to iron particles, aluminium
cannot be held by magnets.
Place car on a flat, level surface.
Correct the oil level of a transmission at operating tem-
perature with the engine idling and the selector lever at
Parking.
If the oil is cold the oil level must be about 1/4 higher than
the minimum mark on the oil dipstick.
The amount of oil between the min. and max. marks is
about 0.6 litre (1 pint).
Caution! Oil level too high: excessive foaming, loss of oil,
temperature increases at high speeds.
Oil level too low: valve rattling, foaming, engine slips
when driving in bends.
Loosen exhaust carrier.
Remove oil pan.
Note when fitting Install the bars and spacers (1) on the
left side.

Check gasket, replacing if necessary.
Only use original gaskets.