A) With automatic bleeding device
Connect the device to the fluid reservoir.

Version with outside clutch throwout arm:
Keep the bleed screw on the clutch slave cylinder open
until no further air bubbles emerge.
During bleeding, depress the clutch pedal repeatedly.

Version with inside clutch throwout arm:
Keep the bleed screw on the clutch slave cylinder open
until no further air bubbles emerge.
At the same time, depress the clutch pedal repeatedly.

B) Without automatic bleeding device
Fill the fluid reservoir.
Connect the bleed hose to the bleed screw on the clutch
slave cylinder.
The other end of the bleed hose must be immersed in a
vessel containing brake fluid, in order to prevent further
air from being drawn in during bleeding.
Depress the clutch pedal fully about 10 times, then hold
it down. Open the bleed screw. When no further air
bubbles emerge, close the screw while holding the clutch
pedal down.
Repeat the entire sequence until no further air bubbles
emerge from the hydraulic system.
Warning: Remember to add more fluid to the vessel in
which the hose is immersed, so that the system cannot
draw in further air.