For versions with a fan housing:
First remove fan housing.
Loosen mounting screws.

Slide up the fan housing until the guide pins are lifted out.
Note when fitting: Place guiede pins in the openings.

Pull out fan housing from below.

Take off radiator cap.
Drain coolant.
Detach hose.

Remove hoses

Detach support.
Lift out radiator.
Note when fitting: Holding land must press down on holder of radiator.

In the case of radiators with a gearbox oi cooler, detach the feed line (top) and return line.

Note when fitting: If there has been gearbox damage,
flush the gearbox oil cooler in the side water tray immediately after
removal with clear gasoline or petroleum. Then set up the radiator so
that the gearbox oil cooler is completely dry before installing it again.