Loosen clamp on throttle butterfly manifold.
Lift air filter housing out of guide rails.
In so doing, pull hose off front panel.

Disconnect pull bar (1).
Remove throttle butterfly manifold (2) from air collector.
(Hoses and pipes must remain connected.)
Note when fitting: Replace sealing (3).
Pull plug (4) off temperature sensor.

Remove plug (5) from starter valve and hoses 6 ÷ 9.

Remove support (10) for auxiliary air slide and all the intake
pipes from the intake manifolds.
Note when fitting: Place shims behind support (10).

Unscrew air collector from angular supports.

Take out air collector together with intake pipes.
Note when fitting: Check sealings and replace in necessary.