 |
|
Prevent the flywheel from turning with retaining catch 7007. On version without locating sleeves: mark the installed position of the flywheel in relation to the crankshaft (dyamic ignition timing mark). Loosen the expansion bolts. Warning:Always install new expansion bolts, using Loctite LT red. Take off the flywheel. |  |
When installing:The friction face may be skimmed if necessary¹). However, the metal thickness at the friction face must not be less than 13.5 mm (0.532 in.) (A).  ¹ See technical data
|  |
